WaterClean is a filtration system that will filter the water in an offset plate processor, from the pre-wash
section in a traditional violet photopolymer processor, or the rinse/wash water section in either thermal/
UV conventional or violet photopolymer plate processors.
Typically the water in the rinse/wash section of the plate processor is contaminated due to carry-over
from the developer section. As the developer has a high pH value, it will over a short time raise the pH
of the rinse/wash water and the development of the plate will continue in the rinse/wash section.
Due to this fact, many production sites have chosen to run with an open tap water configuration, or in a water
savings mode using the highest possible water replenishment rate; both modes consuming more water
that necessary, which is not very environmentally-friendly.
Water Clean has a simple control interface with On/Off and Start buttons and light indicators with warning if pH value is too high or low.
It’s made easy and convenient to exchange the filters when full.
Automatic “Filter Bag full” alarm to indicate when the filter needs to be changed.
WaterClean is equipped with monitoring software and a pH meter which continuously measures the pH value of the water.